Why is my Zanussi dishwasher leaking?

Most likely causes

• 35% The rubber seal around the door deteriorates over time, allowing water to escape during the wash cycle.
• 25% Food debris or kinks in the outlet hose prevent water from draining, causing overflow inside the cabinet.
• 20% The fill valve fails or develops a crack, causing water to leak into the cabinet continuously.
• 12% Seals around the circulation pump wear out, leaking water onto the base of the machine.
• 8% The appliance is not level, causing water to pool and escape during operation.

How to diagnose it

1. 1

   Turn off the water supply

   Locate the water isolation valve under your sink and turn it clockwise to stop water flowing. This prevents further water damage whilst you diagnose the issue.

2. 2

   Identify the leak location

   Run the dishwasher on a short cycle and watch where water escapes from. Is it from the door, underneath, or the sides? This narrows down the cause.

3. 3

   Check the door seal

   Open the door and inspect the rubber gasket for cracks, hardening, or debris trapped inside. Clean with a damp cloth. If damaged, the seal must be replaced.

4. 4

   Inspect the drain hose

   Pull out the dishwasher and trace the outlet hose from the machine to the sink. Check for kinks, cracks, or blockages. Straighten any bends and clear debris.

5. 5

   Check the inlet hose

   Examine the hose bringing water in for visible cracks or loose connections at both ends. Tighten the fitting at the back of the machine by hand if loose.

6. 6

   Confirm the dishwasher level

   Place a spirit level on the dishwasher interior floor. Adjust the front feet (twist clockwise to raise, anticlockwise to lower) so the machine slopes slightly backward.

7. 7

   Test after each adjustment

   After each fix, run a short cycle and watch for leaks. If water still escapes, move to the next cause.

FAQs