How to clean your Siemens washing machine filter

Step-by-step

1. 1

   Turn off and unplug machine

   Switch the washing machine off at the wall socket. Wait 30 seconds for residual power to drain.

   💡 Always isolate the appliance before opening internal compartments.

2. 2

   Locate the filter door

   Find the small rectangular or circular panel on the front lower right of your Siemens machine. It typically has a small handle or recess.

   💡 Consult your model's manual if unsure. The filter door colour often matches the machine front.

3. 3

   Open the filter door carefully

   Gently pull the handle or insert a coin to unlock the panel. Turn anti-clockwise if it's a threaded cap.

   💡 Keep a towel nearby—residual water may spill.

4. 4

   Remove the filter cartridge

   Twist the cylindrical filter anti-clockwise and pull it straight out. Empty any visible debris into a bin.

   💡 If stuck, soak the area with warm water for 2 minutes to loosen mineral deposits.

5. 5

   Rinse filter under running water

   Hold the filter under a warm tap. Use your finger to gently dislodge lint, hair and particles from the pleats.

   💡 Run water through both the inside and outside of the filter for complete cleaning.

6. 6

   Clean the filter cavity

   Wipe the inside of the filter housing with a damp cloth. Remove any loose debris or trapped fibres.

   💡 Use an old toothbrush to scrub stubborn deposits in the cavity corners.

7. 7

   Reinsert and secure filter

   Insert the clean filter back into the housing. Twist clockwise until snug—don't overtighten.

   💡 Ensure the rubber seal sits properly for watertight closure.

8. 8

   Close the filter door

   Push the panel back in place and secure the handle or threaded cap. Turn clockwise until it clicks.

   💡 Run a drain cycle or short wash to test for leaks before returning to normal use.

Parts you may need

FAQs